Sensor pump may be clogged.

1. From the the powered-on position, completely cover the sensor window with your hand and toggle the power switch off, on, off, on within 2 seconds to trigger a continuous dispense mode.
2. Stop this mode by removing your hand from the sensor window.
3. If it is still clogged, fill the reservoir with warm water and repeat above steps.

Vérifiez que le câble est en bon état. S'il semble endommagé, cessez d'utiliser l'appareil et contactez l'assistance. Si tout semble normal, vérifiez la source d'alimentation et essayez de l'utiliser pour charger un autre appareil. Nous recommandons un adaptateur USB de 5V et 1A.

The air vent cutout might be clogged. Gently wipe any soap residue from around the white seal under the lid.

A solid white light indicates the unit is fully charged and displays when the unit is powered on. A pulsing white light indicates the unit is charging. A solid red light indicates the unit low on charge.

3-4 hours or until a solid white light is displayed.

Lightly pull the rubber spout to wipe any dried residue.

1. Wipe the sensor window clean. Rubbing alcohol and a microfiber cloth are recommended.
2. Switch the unit off for 5 seconds, then switch the unit back on.